Skip Navigation Website Accessibility
 


ART PHANTOM I PHANTOM POWER SUPPLY

Overview

Direct boxes are the sound engineers’ Swiss Army knife! Here are some examples:

Problem: You need to connect an amplifier’s speaker output to the mic input on a mixer.

Solution: Connect a Phantom I between the speaker output and a mic input with phantom power on the mixer, then set the attenuation switch to –40dB.

Problem: Your PA is humming because there is a ground loop between a signal source and the mixer.

Solution: Connect a Phantom I between the signal source and a mic input with phantom power and set the ground switch to Lift.

Problem: You need to connect an unbalanced line-level source (ie: a synthesizer, another mixer, an effects device, etc.) to a mic input on the mixer.

Solution: Connect a Phantom I between the source and a mic input with phantom power and set the Attenuator switch to –20dB.

Specifications

Signal To Noise Ratio 100dB
Input Level -10 to +40dB
Output Level -10 to +2dB
Input Connections Dual 1/4 in, unbal. inputs are parallel
Output Connections XLR Balanced
Frequency Response 1Hz – 50kHz
Ground Lift Switch
Input Attenuation Switchable signal padding: -20dB
Phantom Power LED Indication when present
Power 9 to 48V DC of phantom power
Dimensions 3.75×2.875×1.5 inches (95mm x 74mm x 40mm)
Weight 0.7lbs (317g)

Downloads